PrerequisitesEnsure you have the following:
- 1 x Opsview Master (or Slave) connected to both (or more) networks.
Step 1Create a monitoring model in which you divide your host into smaller chunks. These chunks (or building blocks) represent the various parts of the system (e.g. hardware, network, operating system, applications and application interfaces). Each chunk can then be assigned to either the management network or the production network. Below is an example on how you can use these chunks to assign them to a network segment.
Step 2Update the host to reflect the various addresses it has. Using the Opsview WebUI go to the Configuration > Hosts and select Action > Create new host.
In the Other Hostnames/IP’s field we can add our other IP’s of FQDN’s (as shown also adding the primary IP is good practice) in a comma-separated list for each IP you wish to assign to this host. Save the host (later on we will assign host-templates and service checks).
Step 3Confirm from the commandline that you can reach your host using the addresses listed in the “Other Hostnames/IPs” by running one check for a management service and one for a production service.
Check_nrpe -H primary-ip Check_tcp -H secondary-ip -p 80 (for a webserver)
Step 4Set up the service checks. Now to use the defined “Other Hostnames/IPs” we need to change some of our service-checks. The easiest way is to clone a check you already use and give it a new name (e.g. SSH to SSH Management).
As you see from the arguments line, the check will run against the macro know as $HOSTADDRESS$ which is the equivalent of the “Primary Hostname/IP”. To use the “Other Hostnames/IPs” we have to change this to the macro that represents the IP or Hostname we want. Opsview will automatically place all entries for the “Other Hostnames/IPs” in the macro $ADDRESS1$, $ADDRESS2$ and so on. In this case we want to use our Primary-IP which we also registered as the first “Other address” so it is stored in $ADDRESS1$. This allows us to change our check to have the following arguments:
Using the described method you can now create service-checks and based on your model assign them to the correct $ADDRESS$ value.